P2D0E
Motor Electronics Coolant Pump C Control Module Overtemperature
P2D0E closes the motor electronics pump series: the control electronics integrated in pump C have reported an internal temperature above their limit. Smart pumps protect themselves by derating or switching off, and the module storing the code learns of it through the pump's status feedback. Heat usually comes from running without coolant, from a high load against a blocked branch, or from a defect on the pump board itself. No manufacturer publicly documents P2D0E. Ford's 2019 hybrid summary still covered such pump self-reports as one performance code (P0C73), while its 2024 summary names system overtemperature (98) as a separate auxiliary pump fault type; the 2020 Ford hybrids store P2D04 for pump A. A short to voltage on the pump C command line would be P2BD6, not this code. If pump C shuts down, power is limited.
Possible causes
- Pump C running with too little coolant or air medium
- Blocked branch raising pump load and electronics temperature medium
- Defective control board inside pump C medium
Symptoms
- Code sets mainly in heat or after long high-load operation
- Pump C switches off and restarts after cooling
- Warning lamp and reduced power
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2D0E
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.