P2D09
Motor Electronics Coolant Pump B Control Module Overtemperature
P2D09 is raised when the controller inside motor electronics coolant pump B reports that it has become too hot. The pump's own electronics are cooled by the fluid it moves, so the code often follows dry running, a blocked line that makes the motor draw high current, or a mounting spot exposed to heat; an internal defect in the pump board is the other possibility. No manufacturer publicly documents P2D09. Ford's 2024 summary contains the same fault category (98, system over temperature) for its auxiliary pumps, while on pump A the 2020 Ford hybrids log P2D04, which the bulletins cured with new software. Unlike the supply code P2D08 the wiring is usually fine here. When the pump throttles itself, the inverter it serves can overheat and the drive limits power.
Possible causes
- Low coolant or air, so pump B electronics lose their cooling medium
- Restricted line or clogged component raising pump load and current medium
- Internal defect of the pump B control board medium
Symptoms
- Code appears mainly in hot weather or under sustained load
- Pump B switches off temporarily
- Warning lamp and reduced power
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2D09
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.