OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2CFD

A/C Clutch Control Circuit Low

P2CFD means the voltage on the clutch coil output reads lower than the module expects for the commanded state, most often because the line or the coil is grounded. With a high-side driver that short pulls the feed down, so the clutch cannot engage and the driver may protect itself; on a low-side design a grounded line would hold the clutch in instead. Ford is the documented user: on Explorer and Aviator built for 2020–2023, SSMs 50811 and 51380 group P2CFD with P2CFC and P0645 as climate-module codes caused by damaged terminals at body control module C. No public threshold exists; the closest published logic is GM Europe's relay check for P0646 on the 2011 Saab 9-5. The general fault is P2CFC, the opposite level P2CFE.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberC / FD

Possible causes

  • Clutch feed wire chafed through and touching ground high
  • Damaged terminals at the body control module (Ford SSM 50811/51380) medium
  • Clutch coil shorted internally to its housing medium

Symptoms

  • No cooling, compressor clutch stays disengaged
  • Possibly blown fuse in the clutch feed

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2CFD

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication