OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2CFA

Belt Integrated Starter Generator Belt Tensioner Control Circuit Low

P2CFA is logged when the control line of an electrically adjusted BISG belt tensioner reads too low, typically a ground short or a driver that holds the line down permanently. The tensioner's reaction varies with the design: Ford's patent US 9,297,445 describes an actuator that defaults to high belt tension when power is lost, which protects starts but costs efficiency, while a solenoid unit like the one in Hyundai/Kia's US 10,648,544 may rest in its spring position. No manufacturer publicly documents P2CFA. California's rules demand a circuit check on output components; in this case that means comparing the commanded state with the voltage or current returned by the driver. Chafed wiring near the hot accessory drive is a prime suspect. An open circuit is P2CF9, a high signal P2CFB.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberC / FA

Possible causes

  • Tensioner control wire chafed through to ground high
  • Internal short in the tensioner actuator medium
  • Water or corrosion bridging pins at the actuator plug low

Symptoms

  • Stop-start no longer active
  • Belt noise at start or under load
  • Warning lamp on

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2CFA

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication