OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2CF3

Hybrid/EV Battery Pack Coolant Pump A Underspeed

P2CF3 is set when battery coolant pump A turns more slowly than the controller commands, although it is powered and not fully blocked. Typical reasons are a sluggish bearing, deposits on the impeller, low supply voltage or a pump motor that has lost strength; a faulty speed signal can produce the same picture. Ford uses P2CF3 on 2020 hybrids: bulletin 20-2221 (Escape HEV produced until 10 June 2020, code stored in the BECM) and 20-2293/20-2345 (Explorer, Aviator and Police Interceptor Utility hybrid) clear it, along with other pump codes, by reprogramming once the coolant level has been confirmed as correct. In Ford's 2024 OBD summary underspeed is a separate pump failure category (B2). Overspeed or dry running is P2B29, a seized pump P0CFF. The battery may run warmer and power may be limited.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberC / F3

Possible causes

  • Battery controller software misreading pump speed (Ford 2020 hybrids) medium
  • Worn bearing or deposits slowing the pump high
  • Voltage drop on the pump feed or ground under load medium
  • Implausible speed feedback from the pump electronics low

Symptoms

  • MIL or hybrid system warning
  • Battery temperature higher than usual
  • Reduced drive or charging power

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2CF3

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication