P2CED
Particulate Filter Pressure Sensor D Circuit High
With P2CED the analog output of filter pressure sensor D lies above its usable top end. Ford's gasoline OBD document for 2024–25, with filters on both banks and up to four pressure sensors, sets the code above 4.73 V lasting 5 s. That usually traces back to an open sensor ground, a signal line touching the 5 V reference or battery voltage, or an open signal wire on an input with a pull-up. A real pressure that high would mean an almost fully blocked filter, which the separate functional test P2CEB and the restriction monitor would show differently. No other maker documents sensor D; GM's diesel tables only cover C (P2CE8). Disconnecting the sensor and watching the reading jump helps locate the fault side. The low-voltage code is P2CEC.
Possible causes
- Sensor ground open or high resistance high
- Signal wire shorted to 5 V reference or battery voltage medium
- Sensor D failed with output stuck high medium
Symptoms
- Warning lamp on
- Live data shows sensor D at maximum with the engine at idle
- Filter monitoring for that bank incomplete
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2CED
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.