P2CEC
Particulate Filter Pressure Sensor D Circuit Low
P2CEC is set when an analog filter pressure sensor D delivers less voltage than it can in normal service. In Ford's 2024–25 petrol summary, the only public source using sensor D, the limit is 0.3 V for 5 s, checked continuously alongside the A, B and C sensors of the gasoline particulate filters. Practically this means a signal shorted to ground, a 5 V supply that has dropped out, or an open signal line that the module pulls down. A shared reference fault would bring other sensor codes up together. GM does not use sensor D; its C sensor counterpart P2CE7 shows a similar ground-short logic on 2025 diesels. CARB requires out-of-range checks on such inputs. The pressure drop across that bank's filter is then unknown. Too high is P2CED, intermittent P2CEE.
Possible causes
- Signal wire of sensor D shorted to ground high
- 5 V reference to sensor D open or pulled down medium
- Sensor D failed with output stuck low medium
Symptoms
- Warning lamp on
- Live data shows sensor D at minimum
- Further 5 V sensor codes if the shared supply is affected
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2CEC
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.