OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2CE8

Particulate Filter Pressure Sensor C Circuit High

P2CE8 is the high-side electrical fault of filter pressure sensor C: its output sits above the range a working sensor can produce. GM's 2025 diesel tables aim this test at a broken line or a battery-voltage short and set the code when the raw signal of the downstream relative pressure sensor exceeds 99.80 % in 158 of 200 samples (12.5 ms task), Type B with two trips. On Ford's 2024–25 gasoline particulate filters with analog sensors the limit is 4.73 V for 5 s. An open sensor ground or a signal wire touching the 5 V reference are the usual electrical causes; heat-damaged harness sections near the exhaust deserve a close look. Because a pinned-high value would look like an extremely full filter, the controller ignores it. Low voltage is P2CE7, the D sensor equivalent P2CED.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberC / E8

Possible causes

  • Sensor ground or signal wire open high
  • Signal wire shorted to 5 V reference or battery voltage medium
  • Sensor C internally failed with output stuck high medium

Symptoms

  • Warning lamp on
  • Live data shows sensor C at maximum even at idle
  • Regeneration requests may become more frequent

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2CE8

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication