OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2CE7

Particulate Filter Pressure Sensor C Circuit Low

P2CE7 means the raw signal of filter pressure sensor C has dropped below its electrical floor, the typical picture of a signal wire shorted to ground or a lost 5 V supply. GM's 2025 diesel tables, where C is the relative pressure sensor behind the particulate filter, set it when the raw value is under 0.02 % in 158 of 200 samples taken every 12.5 ms with the ignition in range and the engine not cranking; it is Type B, so the lamp follows on the second trip. Ford's 2024–25 petrol summary uses the same code for an analog sensor C on its gasoline particulate filters, with a limit of 0.3 V held for 5 s. Checking reference, ground and signal at the plug comes before replacing the sensor. The high counterpart is P2CE8; sensor D has P2CEC.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberC / E7

Possible causes

  • Signal wire of sensor C shorted to ground, often from heat damage near the exhaust high
  • 5 V supply to the sensor interrupted medium
  • Sensor C internally failed with output stuck low medium

Symptoms

  • Warning lamp on
  • Live data shows sensor C at minimum regardless of engine load
  • Regeneration planning relies on a soot model only

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2CE7

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication