P2CE5
Particulate Filter Pressure Sensor C Circuit
Two manufacturers use P2CE5, with different meanings. In GM's 2025 diesel tables 25OBDG04A and 25OBDG04B, sensor C is the downstream relative pressure sensor that reads gauge pressure behind the particulate filter. Despite the circuit title, GM uses the code as an offset test without exhaust flow: with the engine stopped the reading should be zero, and an offset learned more than 2.20 % away from its nominal value sets a Type B fault without debounce. Ford's 2024–25 petrol summary, which covers particulate filters on both banks, uses P2CE5 for the general circuit fault of a digital SENT sensor C, registered within 5 s; lost communication with it is U0696. A drifted sensor, condensate in the hose or a damaged connector are typical. Regeneration and back pressure monitoring lose a measured input.
Possible causes
- Sensor C zero point drifted (offset at standstill too large) high
- Condensate or soot in the sensing hose holding pressure medium
- Damaged connector or wiring of a digital sensor C medium
- Sensor C internally faulty low
Symptoms
- Warning lamp on, usually after two trips on GM diesels
- Particulate filter regeneration may run less accurately or more often
- Usually no noticeable change in driving
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2CE5
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.