OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2CE4

Intake Air Heater C Circuit High

P2CE4 is stored when heater C's circuit shows an excessive signal, typically a short to battery voltage on the control line or a relay that remains switched on. Volvo and Mack document it as P2CE4-12, the suffix standing for a short to battery. It appears in their pre-heat relay instructions for Volvo VN/VNL/VNR/VNX/VHD and Mack Anthem, Granite, Pinnacle and other models from 2014, where technicians first check terminal tension at element and relay and the EMS software, then fit a new relay, supply cable and an updated two-point bracket (2022 version). A heater stuck on can flatten the batteries and overheat the cable, so this fault deserves quick attention. P2CE3 is the low-side code, P2CE1 the open circuit; heater A and B use P0542 and P2608.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberC / E4

Possible causes

  • Pre-heat relay contacts welded or stuck closed high
  • Control line of heater C shorted to a battery-voltage wire medium
  • Faulty supply power cable or loose bracket mounting affecting the circuit medium
  • Engine control module output stage for the relay faulty low

Symptoms

  • Batteries drained after the truck has been parked
  • Hot or discoloured cable near the heater
  • Warning lamp and possibly hard starting if the heater no longer switches

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2CE4

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication