P2CE3
Intake Air Heater C Circuit Low
P2CE3 means the signal in the circuit of intake air heater C reads too low, as with the control or feedback line shorted to ground or a relay output pulled down. Volvo uses it with the suffix -11, which in the failure type scheme denotes a ground short. The August 2020 EMS change log for Volvo trucks with US17 and OBD2019 engines lists P2CE3-11 among the codes reduced by a pre-heat relay robustness update released in February 2019, and Volvo's 2020 supplementary instruction KC-15 for the pre-heat relay includes it as well. That instruction applies only from US10+OBD13 trucks onward and has relay and supply power cable replaced as a pair. P2CE4 is the high-side code, P2CE1 the open circuit; for heater A the low code is P0541.
Possible causes
- Control or feedback wire of heater C chafed through to ground high
- Pre-heat relay with an internal fault pulling its output low medium
- Outdated engine management software, addressed by a Volvo update medium
- Moisture or corrosion in the relay connector creating a path to ground low
Symptoms
- Pre-heat not working, hard cold starts
- White smoke after starting in cold weather
- Fault lamp on the dash
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2CE3
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.