OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2CDC

Cold Start Cylinder 2 Deactivation/Intake Valve Control Performance

With P2CDC the control unit reports that cylinder 2 did not take the valve state that the cold start routine asked for. Timing matters here: in a Ford patent on electrically latched rockers, intake deactivation is wanted at engine start, yet the cam of cylinder 2 sits on its lobe, so its latch pin cannot move at first. That is normal; the solenoid is pulsed again after roughly 200 to 280 crank degrees and only then must a current dip prove the pin moved. A missing dip with the cam on base circle points to a seized pin or a pumped-up lash adjuster. No maker documents P2CDC publicly; outside the cold start phase GM files the same failure on the L84 as P3499 and the generic code is P3410. The driver mainly notices a shaky warm-up.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberC / DC

Possible causes

  • Latch pin on cylinder 2 seized by dirt or varnish in the oil high
  • Hydraulic lash adjuster pumped up so the rocker stays loaded on base circle medium
  • Weak cylinder 2 solenoid or high resistance in its connector medium
  • Worn cam lobe or collapsed lifter on cylinder 2 low

Symptoms

  • Uneven idle while the engine warms up
  • Warning lamp, sometimes with a cylinder 2 misfire code
  • Engine control may suspend the cold start strategy

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P2CDC

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication