P2CDB
Cold Start Cylinder 1 Deactivation/Intake Valve Control Performance
P2CDB is part of the monitoring of cold start emission strategies: some engines shut off cylinders or hold intake valves closed right after a cold start to heat the catalyst faster, and CARB requires the commanded elements of such a strategy to be checked while it is active. CARB also asks for faults found during the cold start strategy to carry codes distinct from the ordinary ones, which is why this code exists beside P3402. No manufacturer documents P2CDB publicly. Ford monitors P3402 continuously during deactivation, entry and exit from 400 rpm, once oil pressure has had about two seconds to build. A Ford patent chooses the valve state at start by engine temperature and detects latch pin motion from a dip in solenoid current. Expect higher cold start emissions and a cylinder 1 misfire.
Possible causes
- Latch pin of the switchable rocker or lifter on cylinder 1 sticking, often from contaminated oil high
- Wrong oil grade or low oil level slowing the switching while the oil is still cold medium
- Cylinder 1 control solenoid responding sluggishly at low temperature medium
- Engine control software misjudging the cold start test, cured by an update low
Symptoms
- Check engine lamp after a cold start
- Rough running in the first minutes after starting a cold engine
- Misfire code for cylinder 1 stored alongside
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P2CDB
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.