P2CD8
Turbocharger/Supercharger Boost Sensor D Circuit Low
P2CD8 is stored when the voltage from boost sensor D falls below the lowest value a healthy sensor can output. Since these sensors rise in voltage as pressure rises, a reading near zero almost always points to the electrics: signal shorted to ground, an interrupted 5 V supply, or a broken signal wire that the module pulls low. No manufacturer publishes limits for sensor D. For sensor A, Ford's 2024 petrol engines use under 0.19 V held for 5 s, and the GM-developed Saab 2.0 turbo under 0.09 V for more than 5 s as a Type B fault. If other 5 V sensors report low at the same moment, the shared reference circuit is the first suspect. The module then stops regulating boost on that path. Too high is P2CD9.
Possible causes
- Signal wire of sensor D shorted to ground high
- 5 V reference to the sensor open or shorted medium
- Sensor D internally failed with output stuck low medium
Symptoms
- Warning lamp on
- Only base boost available, clear loss of power
- Live data shows sensor D at or near minimum pressure even under load
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2CD8
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- law.cornell.edu/regulations/california/13-CCR-1968.2
- fordservicecontent.com/Ford_Content/catalog/motorcraft/OBDSM2400OUTPUT_16Jul2024_WSM_final_V2_MCS7001.pdf
- saabwisonline.com/9-5-9650/2011/2-engine/engine-management-and-fuel-system-2-0-l-petrol/fault-diagnosis-diagnostic-trouble-codes/dtc-p0236-p0237-or-p0238