P2CD7
Turbocharger/Supercharger Boost Sensor D Circuit Range/Performance
With P2CD7 the boost sensor D signal is electrically valid but does not fit the other pressure readings or the engine's air model. No manufacturer documents this code publicly; the checks used for sensor A show what it would cover. Ford's 2024 petrol summary compares barometric, manifold and boost pressure at key-up after at least 10 s off, allowing roughly 2.1 to 2.7 inHg between pairs, and repeats a two-way comparison at low throttle below 1,500 rpm. The GM-designed Saab 2.0 turbo expects 50 to 115 kPa with the engine stopped and treats deviations as a two-trip Type B fault. Typical reasons are a blocked or leaking pressure tap, oil in the sensor port and drift. Unlike P2CD6, P2CD8 and P2CD9, wiring is rarely to blame here. Expect a lamp and reduced boost.
Possible causes
- Sensor D drifted or contaminated with oil high
- Leaking seal or blocked port at the sensor's measuring point medium
- Charge air leak in the section monitored by sensor D medium
- Sensor with the wrong pressure range fitted low
Symptoms
- Warning lamp on
- Boost limited, weaker acceleration
- Scan tool shows sensor D value differing from barometric pressure with the engine off
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2CD7
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- law.cornell.edu/regulations/california/13-CCR-1968.2
- fordservicecontent.com/Ford_Content/catalog/motorcraft/OBDSM2400OUTPUT_16Jul2024_WSM_final_V2_MCS7001.pdf
- saabwisonline.com/9-5-9650/2011/2-engine/engine-management-and-fuel-system-2-0-l-petrol/fault-diagnosis-diagnostic-trouble-codes/dtc-p0236-p0237-or-p0238