P2CD6
Turbocharger/Supercharger Boost Sensor D Circuit
A fourth boost pressure sensor, D, is only needed where charge pressure is read at four points, for example on twin-turbo engines with two stages per bank or on combinations of supercharger, turbocharger and electric compressor. Which tap gets the letter is up to the manufacturer. P2CD6 is the umbrella fault for this sensor's circuit when the module does not or cannot separate low, high and implausible readings; those have their own codes P2CD7 to P2CD9. No manufacturer documents P2CD6 publicly, and no lost-communication code for a digital sensor D is defined. CARB requires every such input to be checked for circuit faults. By analogy with sensor A, Ford's 2024 petrol engines check the signal continuously and need 5 s to register a fault. Boost control on the affected path is usually cut back.
Possible causes
- Corroded or loose connector, chafed wire at sensor D high
- Boost sensor D internally faulty medium
- 5 V reference or sensor ground interrupted medium
- Input stage of the engine control module faulty low
Symptoms
- Warning lamp on
- Reduced boost and noticeably less power
- Other sensor codes at the same time if a shared 5 V supply is affected
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2CD6
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.