P2CD0
Hybrid/EV Battery Pack K Deterioration
With P2CD0 the battery controller reports that section K, the eleventh separately judged part of the high-voltage battery, has exceeded its ageing limit. Such a verdict normally rests on comparing what this section stores and delivers with its neighbours over many charge cycles, so it rarely appears suddenly after one event. No manufacturer publishes P2CD0; published section-level codes stop at eight groups (Audi Q5 PHEV, P2CCD). Only a battery split into eleven or more monitored units would ever reach it. California's OBD rule requires such codes to narrow faults down to the smallest unit that can be replaced. Before a module is renewed, a thermal cause should be ruled out, since overheating of section K is reported separately as P2D4F. Range and available power drop, and the MIL usually lights.
Possible causes
- Cells of section K lost capacity faster than the other sections high
- Internal resistance of section K increased, limiting power medium
- Uneven coolant flow leaving section K warmer over years low
Symptoms
- Warning lamp for engine or hybrid system
- Shorter range on a full charge
- Weaker acceleration on battery power
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P2CD0
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.