P2CCE
Hybrid/EV Battery Pack I Deterioration
P2CCE is reserved for the ninth section, I, of a traction battery whose controller rates the health of each section on its own. The fault is a capacity or power verdict, not an electrical one: section I no longer delivers what a healthy unit should. No manufacturer publicly documents P2CCE. The nearest published use is Audi's Q5 PHEV, which splits its pack into eight groups and therefore stops at P2CCD for group 8; a battery with nine or more independently monitored modules would continue here, followed by P2CCF for section J. CARB asks for a state-of-health monitor for hybrid storage and, for faults of cells, sensors and cell balancing, for codes that isolate the smallest replaceable unit. Where it is used, expect the MIL, a shorter electric range and, as with Audi's siblings, the replacement of a single module rather than the whole battery.
Possible causes
- Module or cell group of section I aged beyond its limit high
- Uneven pack temperature stressing this section medium
- Misjudged state of health in the battery controller low
Symptoms
- MIL or hybrid system warning on
- Shorter electric range
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P2CCE
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.