P2CCA
Coolant Pump Speed Sensor Circuit Low
P2CCA is stored when the signal line of the coolant pump speed sensor remains below its lower limit, so no pulses or levels above the threshold arrive. Most often the signal wire is shorted to ground, the sensor has lost its supply voltage and therefore cannot switch, or its output stage has failed in the off state. No manufacturer documents P2CCA publicly. The measured pump speed matters to the controller because, as GM's patent US20160047374A1 explains, it is compared with the target speed to judge whether the pump works; with a dead signal that check is impossible. CARB requires out-of-range checks of such inputs. Measure supply and ground at the sensor plug first, then the signal wire to ground. The opposite level is P2CCB, implausible values P2CC9.
Possible causes
- Signal wire shorted to ground high
- Sensor supply voltage missing because of an open feed medium
- Sensor output stage failed in the low state medium
Symptoms
- MIL on
- Pump speed reads zero in live data although the engine runs
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2CCA
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.