P2CC8
Coolant Pump Speed Sensor Circuit
Some engines measure how fast a coolant pump turns with a dedicated speed sensor, for instance on a pump that can be engaged and released or on an electric pump read back by the controller. P2CC8 is the general fault of that sensor's circuit: the signal is absent or cannot be used, without the controller deciding whether it is too low or too high. No manufacturer documents P2CC8 publicly. GM's patent US20160047374A1 describes how a measured pump speed, compared with the target, lets the controller diagnose an electric main coolant pump; Audi's patent US8915127B2 shows that without such a signal a switchable pump can only be judged indirectly through cylinder head temperature. CARB requires monitoring of coolant flow devices other than a thermostat. Expect a MIL and a default pump state.
Possible causes
- Failed speed sensor delivering no usable signal high
- Damaged wiring or loose connector at the sensor medium
- Missing reference voltage or ground for the sensor low
Symptoms
- MIL on
- Coolant pump held in a default state, warm-up may change
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2CC8
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.