P2CC7
Generator Inverter Power Supply B Circuit High
P2CC7 is set when supply B of the generator inverter exceeds its upper limit. Gate inputs of IGBTs tolerate only a limited voltage, so overvoltage on the driver rail puts the switches at risk and the inverter is normally shut down. Ford shows that such rails have a hard ceiling: in its 2019 hybrid OBD summary a motor or generator gate drive supply above 15.08 V counts as a fault, although Ford reports it under a rotor position circuit voltage check, and for the variable voltage converter the window runs from 0.1 V to 15.3 V. No manufacturer documents P2CC7 publicly. A faulty internal regulator or a short between supply rails is most likely. CARB demands circuit monitoring of hybrid components. Siblings: P2CC5, P2CC6; supply A high is P0E11.
Possible causes
- Regulator of supply B inside the inverter faulty medium
- Short between two internal supply rails medium
- Overvoltage in the 12 V system from a DC/DC converter fault low
Symptoms
- Hybrid system warning light and MIL on
- Generator blocked, battery no longer charged while driving
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P2CC7
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.