P2CC3
Generator Voltage Sense Circuit B Low
P2CC3 is stored when generator sense circuit B reports a voltage below its lower limit, in practice often close to zero. Typical causes are an open sense lead, a blown fuse in it or a short to ground; on Chrysler alternators, according to Remy, an internal 2.4 kΩ resistor shields the sense terminal against such a ground fault. The risk lies in the regulation: if the controller believed a too-low reading, it would raise field current and overcharge the battery, which is why a controller that has recognised the fault can fall back to a substitute value or a fixed set point instead. No manufacturer documents P2CC3 publicly. CARB demands MIL monitoring of charging inputs only where emissions or other diagnostics depend on them. High signal: P2CC4; circuit A low: P063C.
Possible causes
- Sense wire B broken or its fuse blown high
- Sense wire B chafed and shorted to ground medium
- Corroded sense terminal at the alternator or module medium
Symptoms
- Charging warning lamp on
- Charging voltage too high or held at a fixed value
- Overcharged battery, bright lights
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2CC3
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.