P2CBE
PCV Heater B Control Circuit High
P2CBE says the switched control line of PCV heater B carries too high a voltage, usually because it touches battery positive. Since the module normally completes the heater circuit by pulling this line to ground, a short to supply means the output can no longer switch the element on, or the driver shuts down to protect itself, so heater B stays cold. No manufacturer documents P2CBE publicly. GM checks the A-side equivalent P053C on 2016 diesels with the same 20-of-40 sample counter below 90 °C as its open and ground tests, Type C; the Saab 9-5 2.0 diesel looks for 3–4 V on the low reference with the connector unplugged. Look for chafed insulation near hot parts. Note that in the B group the High code comes before Low.
Possible causes
- Control wire chafed through and touching battery voltage high
- Moisture bridging pins in the heater B connector medium
- Internal short in heating element B low
- Damaged output stage in the engine control module low
Symptoms
- Code stored, MIL depending on manufacturer
- Heater B inactive, risk of an iced ventilation path in frost
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2CBE
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.