OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2CBA

Fan 2 Overspeed

With P2CBA the controller finds fan 2 spinning clearly faster than its own estimate of what the current command should produce. GM documents the check in tables 23OBDG07 and 24OBDG07: the reported speed minus the estimated speed must exceed a margin of 1400 to 4050 rpm, depending on the operating point, for 20 s with more than 9.5 V on board, and the lamp follows on the second trip. A separate GM code covers readings beyond 4999 rpm that cannot be real, so P2CBA points to a fan that really turns too fast or a motor controller that ignores its command. Typical reasons are a broken or missing blade section, a damaged shroud letting the rotor run free, or a fan module that drives at full power. GM's 2025 diesel table does not use P2CBA. Underspeed of the same fan is P2CB9, fan 1 overspeed P0495.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberC / BA

Possible causes

  • Fan blade broken or partly missing, less load on the motor high
  • Fan electronics drive the motor harder than commanded medium
  • Implausible speed feedback from the fan module medium
  • Shroud damaged or detached so the rotor runs free low

Symptoms

  • Check engine light after two trips
  • Unusually loud or vibrating fan noise
  • Fan runs at high speed even with a cool engine

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2CBA

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication