P2CB2
Charge Air Cooler Coolant Pump B Underspeed
With P2CB2 the speed reported by charge air cooler pump B stays below what it should reach. The motor is braked mechanically or gets too little power: a dragging bearing, debris or sludge at the impeller, a weak supply or a high-resistance connector. No manufacturer documents P2CB2 publicly. GM's pump A version, P2B84 in table 25OBDG04B, trips on a reported speed below −115 rpm, effectively a stopped or backward-turning rotor, in 8 of 10 samples with at least 11 V, Type B. GM bulletin 23-NA-102 traced such pump faults on the 3.0-litre Duramax to water getting into the plug of pump M10, a reminder to inspect the connector first. Less flow means warmer charge air and possible power loss. A rotor that cannot move at all is P2CB3.
Possible causes
- Dragging bearing or sludge slowing the rotor of pump B high
- Water or corrosion in the pump connector raising resistance medium
- Low supply voltage from a poor ground or weak battery medium
Symptoms
- MIL on after two trips
- Charge air runs hot, engine power reduced under load
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2CB2
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.