P2CB1
Charge Air Cooler Coolant Pump B Overspeed/Air In System
P2CB1 means pump B in the charge air cooling loop turns faster than it should. An electric pump loses its hydraulic load when the impeller churns air instead of coolant, so overspeed is mostly a symptom of a low level or poor bleeding. No manufacturer documents P2CB1 publicly. For pump A (P2B83), GM's 2025 diesel table 25OBDG04B treats 8,500 rpm or more in 8 of 10 one-second samples as a fault, at 11 V or higher, Type B with MIL after two trips. GM's LT4 bulletin 18-NA-291 adds that this kind of pump shuts itself off once it draws air, which is why the loop there has to be vacuum filled. Check level, leaks that suck in air, and the bleed procedure before replacing pump B. If the pump then overheats, P2CB5 may follow.
Possible causes
- Air trapped in the loop after service or incomplete bleeding high
- Low coolant from a leak in the charge air cooler circuit high
- Impeller loose or broken on the shaft of pump B low
Symptoms
- MIL on after two trips
- Gurgling or a high-pitched pump noise
- Low coolant warning or falling expansion tank level
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2CB1
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.