P2CAE
Charge Air Cooler Coolant Pump B Control Circuit Low
P2CAE concerns the second electric pump of a charge air cooling loop: its control line is held at ground potential where the driver expects a higher level. No manufacturer documents pump B publicly. GM's published test for pump A (P023B, LT5, table 19OBDG03A) runs with the low-side driver off and flags a short to ground when output and controller ground are connected by less than 0.5 Ω, again 50 of 63 samples, Type A. What the pump then does depends on its design: a plainly switched motor may run all the time, while a smart pump that reads a missing PWM signal may fall back to an emergency mode. Look for a harness chafed on a bracket, water between pins, or an internal short in pump B. The opposite fault, a short to power, is P2CAF.
Possible causes
- Control wire of pump B rubbed through to ground high
- Water or corrosion in the pump B connector medium
- Internal short in the electronics of pump B low
Symptoms
- MIL on
- Pump B runs continuously or stays in a fallback mode
- Possible power reduction when the charge air gets hot
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2CAE
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.