P2CAD
Charge Air Cooler Coolant Pump B Control Circuit/Open
Where a charge air cooling loop has a second electric pump, it carries the letter B. P2CAD reports that the control line to that pump is open, so the driver stage in the engine computer sees no load. No manufacturer documents a pump B or this code publicly. GM publishes the matching test for pump A (P023A) on the supercharged LT5 in table 19OBDG03A: with the low-side driver switched off, more than 200 kΩ between output and ground counts as open; 50 failed samples out of 63 at 100 ms, main relay at least 11 V, Type A with MIL on the first trip. Unplugged or corroded connectors, a broken wire or an open motor winding are the common finds. A pump driven only over LIN has no such line and would report through U01BC instead.
Possible causes
- Pump B connector loose, unplugged or corroded high
- Broken control wire between engine module and pump B medium
- Open motor winding or internal board fault in pump B medium
Symptoms
- MIL on, often after the first trip
- Pump B silent; charge air temperature rises under load
- Reduced engine power
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2CAD
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.