P2CAC
DC/DC Converter Temperature Sensor F Circuit Range/Performance
P2CAC flags DC/DC converter temperature sensor F as implausible although its signal is electrically valid. With six sensors in one converter the controller has plenty of reference values: after a cold soak all should read close to ambient, and during operation sensor F should rise and fall in step with the load on the part it watches. The Hyundai patent shows that converter software already evaluates temperature differences between sensors, there to tune the switching frequency. No manufacturer documents P2CAC publicly; FCA's Ram 1500 eTorque bulletin 08-037-21 only covers performance codes up to sensor D. CARB requires rationality checks for hybrid component temperature sensors. A sensor detached from its heat sink, drift or outdated software are typical. Sensor E uses P2CA8.
Possible causes
- Sensor F detached from its heat sink or measuring point medium
- Sensor F drifting against the other converter sensors medium
- Outdated converter or hybrid control software medium
- Uneven cooling of the converter, e.g. air in the coolant circuit low
Symptoms
- MIL on, sometimes after a single drive
- Sensor F reading out of line with the other converter temperatures
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P2CAC
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.