P2CAB
DC/DC Converter Temperature Sensor F Circuit High
P2CAB is set when DC/DC converter temperature sensor F delivers a voltage above the top of its valid band. For a thermistor input this is the typical signature of an open circuit, since the pull-up drags the line to reference voltage, or of a short to a higher voltage. The resulting value would be colder than the surroundings, which a working converter can never be. No manufacturer documents P2CAB publicly; bulletins name converter sensors only up to letter D. CARB requires range monitoring of hybrid input components. Checking the connector at the converter, its locking and the terminals for spread or corrosion comes first, as the sensor is frequently built into the converter assembly. P2CAA is the low counterpart, P2CA7 the same fault for sensor E.
Possible causes
- Converter connector not latched or terminals spread high
- Broken signal or return wire of sensor F medium
- Signal line shorted to a higher voltage low
Symptoms
- MIL and hybrid system warning on
- Converter temperature shown far below ambient
- Reduced 12 V supply from the converter
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P2CAB
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.