OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2CAA

DC/DC Converter Temperature Sensor F Circuit Low

P2CAA reports that the input for DC/DC converter temperature sensor F reads too low. With the usual thermistor circuit this corresponds to an impossibly hot reading, so the controller suspects the signal path before the hardware: a ground short in the harness, moisture in the connector or a thermistor that failed short. A useful check is whether the value stays low with the vehicle cold and the converter idle, since a real temperature would have dropped long ago. No manufacturer documents P2CAA publicly, and the lettered converter sensors named in bulletins end at D. CARB requires hybrid input components to be monitored for out-of-range signals. The converter is normally throttled or shut off. Siblings: P2CAB (high), and P2CA6 for sensor E.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberC / AA

Possible causes

  • Sensor F signal shorted to ground in the harness high
  • Moisture or contamination in the converter connector medium
  • Thermistor of sensor F failed short medium

Symptoms

  • MIL and hybrid or charging warning on
  • Very high converter temperature shown even with a cold vehicle
  • Converter limited or switched off

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P2CAA

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication