P2CA9
DC/DC Converter Temperature Sensor F Circuit
P2CA9 is the general fault code for the circuit of the sixth DC/DC converter temperature sensor, letter F. Which component this sensor watches is left to the manufacturer. No manufacturer documents P2CA9 publicly; the converter sensors visible in bulletins end at D (Ram 1500 eTorque, FCA 08-037-21). Why a converter has several measuring points is shown by a Hyundai patent: inductor and both IGBTs are measured separately so that the controller can balance how hot they get. The code serves for input faults that cannot be sorted into low, high or implausible. CARB demands circuit monitoring of hybrid inputs. A derated converter can gradually drain the 12 V battery; sensor E's general circuit code is P2CA5.
Possible causes
- Damaged harness or poor contact in the sensor F circuit high
- Temperature sensor F inside the converter failed medium
- Input stage on the converter control board faulty low
Symptoms
- MIL and hybrid system warning on
- Converter output limited, 12 V voltage may sag
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P2CA9
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.