P2CA8
DC/DC Converter Temperature Sensor E Circuit Range/Performance
P2CA8 covers sensor E of the DC/DC converter when its voltage is electrically fine but the temperature it reports does not make sense. Typical plausibility tests compare all converter sensors after a long soak, when they should agree, or check whether a reading moves at all while the converter is under heavy load. FCA shows the pattern for lower letters: on the 2021 Ram 1500 eTorque, bulletin 08-037-21 lists performance codes for sensors 1, 2, C and D, turning them into one-trip faults with new hybrid control software, but sensor E is not named. No manufacturer documents P2CA8 publicly. CARB explicitly demands rationality monitoring for hybrid component temperature sensors. Drift, poor thermal contact of the sensor or software are the usual suspects.
Possible causes
- Sensor E drifting away from the other converter sensors medium
- Sensor E has lost thermal contact with the part it measures medium
- Outdated converter or hybrid control software with too tight limits medium
- Contact resistance in the connector shifting the signal low
Symptoms
- MIL on, possibly after a single drive
- Converter temperature in live data not following load or ambient
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P2CA8
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.