OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2CA6

DC/DC Converter Temperature Sensor E Circuit Low

P2CA6 is logged when the voltage of DC/DC converter temperature sensor E sits below the lower edge of its window. Converter sensors are usually thermistors whose resistance falls as they warm, so a signal that collapses towards zero would mean a converter hotter than physically plausible. A chafed signal wire touching ground or an internally shorted thermistor is the normal explanation; genuine overheating would first produce smooth, believable readings. No manufacturer documents P2CA6 publicly, and published bulletins only go up to sensor D. CARB requires out-of-range detection on hybrid input components. Because the controller has to assume excess heat, it typically cuts converter power at once. The opposite signal fault is P2CA7.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberC / A6

Possible causes

  • Signal wire of sensor E chafed through and shorted to ground high
  • Thermistor of sensor E shorted internally medium
  • Actual severe overheating of the converter, e.g. coolant loss low

Symptoms

  • MIL and hybrid or charging warning on
  • Converter switched off or strongly limited immediately after start
  • Low 12 V voltage message on longer drives

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P2CA6

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication