OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2C9F

Fuel Pressure Regulator D Exceeded Control Limits - Pressure Too High

P2C9F concerns regulator D, which GM uses for the second quantity control valve of a twin high-pressure system. GM's 2023 and 2024 tables 23OBDG07 and 24OBDG07 carry it in an ECM section that also lists the bank 2 rail sensor codes of bulletin 24-NA-106 for the 5.5 L LT6 Corvette. The table entry trips when the filtered rail-pressure control deviation exceeds 3 MPa for 5 s, with a second path while the tank is empty or on reserve, one trip. Note the oddity: this same criterion is the one GM gives bank 1 underpressure code P228C, while P2CA0 receives the mirror image, so the direction printed in the table appears reversed against the code title. In practice the code points to a valve or sensor of bank 2; P2C01 judges the valve's overall authority.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberC / 9F

Possible causes

  • Second quantity control valve (bank 2) not regulating correctly high
  • Water intrusion or fault in the bank 2 fuel harness connector (GM LT6) medium
  • Bank 2 rail pressure sensor reading implausibly medium
  • Very low tank level causing pressure dropouts low

Symptoms

  • MIL on after one trip
  • Rough running or reduced power
  • Further fuel pressure or bank 2 injector codes stored

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P2C9F

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication