OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2C9D

Fuel Pressure Regulator C Exceeded Control Limits - Pressure Too High

P2C9D reports that the fuel pressure in the section governed by regulator C stays above its target although that regulator is already reducing delivery as far as it can. A third regulator letter is only needed where an engine has several pressure control elements, for instance two high-pressure pumps or separate rail circuits. No manufacturer documents P2C9D publicly. The closest published logic is GM's for regulators A and D (tables 23OBDG07 and 24OBDG07): measured and desired rail pressure may differ by no more than 3 MPa for a few seconds before a one-trip fault is stored. CARB demands a fault once fuel pressure control runs out of authority. Expect a hard, noisy idle or reduced power; P2C9E covers the underpressure side of the same regulator.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberC / 9D

Possible causes

  • Quantity control valve of circuit C sticking in the delivery position high
  • Rail pressure sensor of that circuit reading too high medium
  • Wiring or connector fault keeping the valve from being switched medium
  • Outdated engine control calibration low

Symptoms

  • MIL on, often after a single trip
  • Harsh or noisy idle, especially when cold
  • Reduced engine power

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P2C9D

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication