OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2C9B

Cold Start Turbocharger/Supercharger Wastegate Actuator A Range/Performance

P2C9B checks wastegate A while the engine runs its catalyst warm-up strategy after a cold start, when the wastegate is commanded open so hot exhaust reaches the catalyst rather than the turbine. GM uses the code on the 2.7-litre L3B (table 19OBDG03D): it fails if the position error stays above 20 % for over 1 s, the actuator current above 1 A or the duty cycle above 40 %, judged on 25 of 30 samples at 100 ms; Type A, MIL after one trip. The 2025 table 25OBDG03B tightens the position limit to 10 % over 2 s (29 of 30). In the 19OBDG07 table for GM's twin-turbo 4.2-litre V8 the code flags a bank 1 bypass valve that sticks longer than 1 s during rapid heat-up. Causes are a stiff flap or linkage, a weak electric actuator or wiring. P2B81 covers the actuator outside cold start; P2C9C is turbo B.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberC / 9B

Possible causes

  • Wastegate flap or linkage stiff from corrosion or deposits, worst when cold high
  • Electric wastegate actuator with worn motor or gears medium
  • Actuator position feedback incorrect low
  • Poor contact at the actuator connector or wiring low

Symptoms

  • Check engine light shortly after a cold start
  • Rattle or noise from the wastegate area when cold
  • Often no noticeable change in performance

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2C9B

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication