P2C97
Hybrid/EV Battery Disable Circuit Low
P2C97 is set when the high-voltage battery's wired disable input sits below its valid range, typically because the line is chafed through to body ground or the sending module pulls it low permanently. Whether low means shut down depends on the design. Where the line is active-low, a short to ground looks like a constant request to open the contactors, and the battery stays switched off; where a defined level is expected, the controller simply loses a trustworthy signal. The safety value of a hard-wired path is shown in Volkswagen patent US9586481B2, where it opens the contactor faster than a CAN message. No manufacturer documents P2C97 publicly. A shorted line should be traced section by section between the sender and the battery connector. CARB requires monitoring of hybrid components.
Possible causes
- Disable line chafed and shorted to ground high
- Sending module holding the line low permanently medium
- Water in the connector creating a leakage path to ground low
Symptoms
- High-voltage battery stays switched off, no ready mode
- High-voltage system warning
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P2C97
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.