P2C93
Hybrid/EV Battery Contactor Control Supply Circuit Range/Performance
With P2C93 the supply for the contactor drivers is present but does not behave as it should: it sags when a coil is switched on, ripples, or recovers too slowly before the next contactor in the closing sequence. A high-resistance contact or a weak feed therefore shows up here rather than as an open circuit. LG Energy Solution patent US12007445B2 describes the matching logic: before every contactor closes, the controller compares the supply with a minimum, waits and repeats the comparison if it is short, and only after a set number of failed tries records a supply fault. No manufacturer documents P2C93 publicly. For the driver the effect is often intermittent: the car may need several attempts to become ready or abort charging. CARB requires functional checks of hybrid components.
Possible causes
- Corroded or loose contact in the supply feed causing voltage drop high
- Weak 12 V battery or ground connection sagging under coil load medium
- Contactor coil drawing excessive current or driver stage faulty low
Symptoms
- Several attempts needed before the vehicle is ready
- Charging stops unexpectedly
- Intermittent hybrid or EV warning
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P2C93
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.