P2C8F
DC/DC Converter Temperature Sensor D Circuit High
P2C8F stands for a sensor D signal stuck above the upper edge of its permitted range. With a thermistor fed through a pull-up resistor, the voltage climbs towards the reference as soon as the loop is broken, so an unplugged connector, a cracked wire or a corroded pin is the classic finding; a short to a supply voltage gives the same picture. The resulting reading would be a converter colder than any real ambient. No manufacturer documents P2C8F publicly; FCA shows sensor D on the 2021 Ram 1500 eTorque but lists only P2C8D for it. CARB requires range monitoring of hybrid input components. Because a false cold value could hide real overheating, the controller treats the temperature as unknown and usually limits power. P2C8E is the low-signal counterpart.
Possible causes
- Connector unplugged or sensor wire broken high
- Corroded or pushed-back pin at the converter connector medium
- Signal shorted to a supply voltage low
Symptoms
- Hybrid system warning, MIL possible
- Electrical power limited as a precaution
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P2C8F
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.