P2C8E
DC/DC Converter Temperature Sensor D Circuit Low
P2C8E is logged when the voltage from DC/DC converter temperature sensor D drops under the lower limit of its window. Power electronics mostly use NTC thermistors, where a falling voltage means rising temperature; an implausibly low value therefore reads as a converter far hotter than it can be. The usual culprits are a signal wire touching ground, a crushed harness or a thermistor that has shorted internally, much less often real overheating. No manufacturer documents P2C8E publicly; FCA proves sensor D exists on the 2021 Ram 1500 eTorque but names only P2C8D for it. CARB requires out-of-range checks on hybrid input components. Since the controller has to assume overtemperature, it tends to throttle the converter straight away. P2C8F covers the opposite direction.
Possible causes
- Sensor D signal wire shorted to ground high
- Thermistor shorted internally medium
- Converter genuinely overheating because of a cooling fault low
Symptoms
- Hybrid or charging system warning
- Converter derated right away, less electrical power available
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P2C8E
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.