P2C8C
DC/DC Converter Temperature Sensor D Circuit
P2C8C reports a general fault in the circuit of the fourth temperature sensor of a DC/DC converter, after sensors A, B and C (P0C38, P0C3D, P0E58). Where sensor D sits inside the converter is up to each maker. That such a fourth sensor exists in practice is shown by FCA: the 2021 Ram 1500 with the 3.6 L eTorque mild hybrid watches converter sensors 1, 2, C and D, yet bulletin 08-037-21 lists only the plausibility code P2C8D for sensor D. No manufacturer documents P2C8C publicly. The code fits a signal the controller recognises as unusable but cannot sort into too low, too high or implausible. CARB requires circuit checks on hybrid input components. Without this reading the controller normally reduces converter output, which can weaken support for the 12 V system.
Possible causes
- Sensor connector or wiring damaged or corroded medium
- Temperature sensor D in the converter defective medium
- Sensor reference or evaluation circuit inside the converter faulty low
Symptoms
- MIL or hybrid system warning
- Converter output limited, 12 V charging voltage may drop
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P2C8C
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.