OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2C88

Hybrid/EV Battery Voltage System Isolation Warning

P2C88 is the warning counterpart to P0AA6: the isolation resistance of the high-voltage system as a whole has fallen below a first limit without the monitor yet being able to say whether the battery or the vehicle side is to blame. Mercedes-Benz uses P2C8800 in the battery management system of the 295, 296 and 297 model series; its 2025 bulletin lists it with P2C8500 and P2C8700 when moisture builds up in a high-voltage PTC heater lacking a diaphragm, a fault that starts sporadically and worsens. Legally the complete system must stay above 500 ohms per volt, so the warning leaves time to find the leak before a lockout. Measure each branch separately, starting with components that are switched in only at times.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberC / 88

Possible causes

  • Moisture in a high-voltage component that is only switched in at times (heater, compressor) high
  • Gradual insulation aging in cables or connectors medium
  • Beginning insulation loss inside the battery pack low

Symptoms

  • High-voltage warning message, sometimes towing not allowed notice
  • Electric heater stays cold if it is the leaking part

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P2C88

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication