OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2C86

Hybrid/EV Battery Voltage Internal Isolation Warning

P2C86 is an early warning that the insulation inside the traction battery, between cells, busbars or module electronics and the pack housing, is dropping but has not yet reached the fault limit. The full internal fault is P0E74. No manufacturer documents P2C86 publicly. Mercedes-Benz shows the same content under its own code P142900 (warning, insulation inside the battery) on its 2015-2020 plug-in hybrids. How internal and external are told apart is explained in a Tesla tech note: the battery management system measures inside the contactors, so a low reading with contactors open points to the pack itself, and below 1,800 kOhm in that state the pack was replaced. Coolant or condensation in the pack and damaged module wiring are typical. CARB counts isolation detection as safety-only.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberC / 86

Possible causes

  • Coolant leaking inside the battery pack high
  • Condensation or water ingress through a failed pack seal or vent medium
  • Damaged cell sensing or busbar insulation inside the pack medium
  • Isolation measurement in the battery controller drifting low

Symptoms

  • Battery or high-voltage service message, often without immediate limits
  • Charging may be refused if the value keeps falling

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P2C86

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication