OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2C83

Cold Start Shift Time Too Short

California requires every part of an emission-reducing cold-start routine to be checked while it is active and its faults to be stored apart from ordinary ones. Many automatics take part in that strategy: a warm-up gearshift mode lets the engine rev further before each upshift so engine and catalyst heat faster, as a ZF patent describes. P2C83 belongs to this family. It says a shift measured during the cold-start phase was too quick – the cold-start counterpart of P0895. Whether a maker times each ratio change or how long the warm-up mode lasts is not published, and no manufacturer documents P2C83. For comparison, Saab's 1994 automatic expected each shift to take 0.3–1.3 s. Too short a shift points to excessive clutch pressure or a fill adaptation off target with cold fluid; the result is a harsh first shift.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberC / 83

Possible causes

  • Clutch apply pressure too high while the fluid is cold medium
  • Fill or pressure adaptation for cold fluid outside its target, e.g. after a reset or software fault medium
  • Transmission fluid temperature signal implausible, so the wrong cold-start values are used low
  • Pressure control solenoid sticking or overshooting low

Symptoms

  • Harsh or jerky first upshifts after a cold start
  • Engine or transmission warning lamp
  • Shifting returns to normal once the gearbox is warm

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P2C83

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication