OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2C80

AIR System Pump Overspeed Bank 1

P2C80 says the secondary air pump on bank 1 is turning faster than it should. Newer designs use a brushless motor whose speed is measured: an FCA patent describes a pump with a Hall sensor and target wheel so the controller can infer the air mass delivered from the revolutions and adjust pump speed. If the pump spins too fast for its command, it is working against little or no resistance, or its speed control has lost authority. No manufacturer documents P2C80 publicly; CARB requires secondary air systems and their electrical parts to be monitored. Possible causes are a detached or split outlet hose, a damaged impeller or shaft coupling, and a faulty speed signal or pump electronics. Cold-start emissions rise while the car drives normally. P2C81 is overheating, P2445 a pump that delivers nothing.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberC / 80

Possible causes

  • Outlet hose detached or split so the pump runs without back-pressure medium
  • Damaged impeller or loose coupling between motor and impeller medium
  • Faulty speed signal (Hall sensor) or its wiring medium
  • Defective control electronics inside the pump low

Symptoms

  • Check engine light
  • Louder or higher-pitched pump noise after a cold start
  • Secondary air readiness not completed, emissions test may fail

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2C80

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication