OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2C7E

Turbocharger Turbine Inlet Valve Motor Driver Overtemperature

P2C7E indicates that the driver circuit for the turbine inlet valve motor has grown too hot. Driver chips monitor their own junction temperature and switch off beyond a limit, as the data sheet of NXP's MC33926 H-bridge shows. No manufacturer documents P2C7E publicly; the closest published example is GM's 3.0-litre diesel, where P2B99 for the exhaust pressure valve sets once the H-bridge driver exceeds 170 °C in 240 of 300 samples (Type A, table 25OBDG04B). Heat builds up when the motor has to hold against a stiff or binding valve for long periods, when windings are partly shorted, or when an actuator with built-in electronics sits close to hot turbo parts, a risk the Korean actuator patent also names. After shutdown the valve is uncontrolled and boost is reduced. P2C7D is the overcurrent fault.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberC / 7E

Possible causes

  • Binding valve that keeps the motor under constant load high
  • Partially shorted motor windings raising current and heat medium
  • Actuator electronics overheated by missing heat shield or poor cooling medium
  • Defective driver stage reporting overtemperature low

Symptoms

  • Loss of boost after a longer drive or under high load
  • Check engine light, possibly limp mode
  • Fault may disappear after the engine has cooled down

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P2C7E

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication