P2C6F
Drive Motor A Phase Z Current
P2C6F is the general current fault for phase Z, the third phase of the second winding set of drive motor A. No manufacturer documents it publicly. Whether Z is measured at all depends on the design: the Mitsubishi Electric patent fits a sensor to each of X, Y and Z, while a Hyundai patent describes inverters that measure two phase currents and calculate the third, since all three must add up to zero. In the second case a Z code can arise from an error in X or Y, so the other phases must be checked too. The code covers implausible readings and current that does not follow the command without a clear low or high case (P2C70, P2C71); a sensor circuit fault is P2E23. The driver sees a hybrid or drive warning with reduced or no electric power.
Possible causes
- Error in the X or Y current measurement corrupting a calculated Z value medium
- Phase Z terminal or busbar loose, corroded or overheated medium
- Fault in the Z switching leg or its gate driver medium
- Damaged phase Z winding low
Symptoms
- Hybrid or drive system warning with MIL
- Reduced electric power, possibly engine-only operation on hybrids
- Other X/Y phase codes stored alongside
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P2C6F
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.