P2C6D
Drive Motor A Phase Y Current Low
P2C6D is set when phase Y of drive motor A carries too little current while the inverter drives it, the typical signature of an open phase. No manufacturer documents P2C6D publicly. A test of this kind can run at start-up: on its 2019 power-split hybrids Ford checks the phase circuits right after power-up and declares a fault if less than 5 A flows during the 100 ms test. On a dual-winding motor of the kind shown in a Mitsubishi Electric patent, each winding set is driven separately, so an open Y lead in the second set does not affect U, V and W, but the machine loses torque and runs unevenly. Typical finds are a lifted or burnt terminal, a cracked busbar, a dead switching leg or an open winding. P2C6C is the general Y code, P2C6E the high side.
Possible causes
- Phase Y lead, busbar or terminal open or high-resistance high
- Y switching leg of the inverter not conducting (switch or gate driver) medium
- Phase Y current sensor or its supply failed, reading near zero medium
- Open phase Y winding inside the motor low
Symptoms
- Hybrid or drive warning and MIL
- Noticeably weaker electric drive, vibration or humming under load
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P2C6D
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.